Carbide Tip Two Flute Straight Flute End Mill

 

310both.jpg (19683 bytes)

Style 310
  • These carbide tipped end mills are designed for milling cast, ductile, and malleable iron and well as non-ferrous metals.
  • Used where the machine horsepower is too low for high capacity end mills.
  • Sharp edged for smoother finish.
  • Two straight flutes, right hand cut, non-center cutting.
 
Diameter Tolerance
Nominal Size Cutting Æ Shank Æ
Inch mm Inch mm
All +.0050 +0.127 +.0001 +0.003
+.0000 -0.000 -.0006 -0.015

 

EDP # Cutting Æ "D" Dec Equiv. Overall Length "A" Length of Carbide "B" Shank Diameter "C" No. of Flutes
Inch mm Inch Inch mm Inch mm Inch mm  
31002500 1/4 6.35 .2500 2-1/2 64 1/2 13 3/8 9.525 2
31003125 5/16 7.938 .3125 2-1/2 64 5/8 16 3/8 9.525 2
31003750 3/8 9.525 .3750 2-1/2 64 5/8 16 3/8 9.525 2
31004375 7/16 11.113 .4375 2-11/16 68 1 25 3/8 9.525 2
31005000 1/2 12.7 .5000 3-1/4 83 1 25 1/2 12.7 2
31005625 9/16 14.288 .5625 3-3/8 86 1 25 1/2 12.7 2
31006250 5/8 15.875 .6250 3-3/8 86 1 25 1/2 12.7 2
31007500 3/4 19.05 .7500 3-5/8 92 1 25 5/8 15.875 2
31008750 7/8 22.225 .8750 4 102 1-1/4 32 5/8 15.875 2
31010000 1 25.4 1.0000 4 102 1-1/4 32 7/8 22.225 2
31011250 1-1/8 28.575 1.1250 4-1/4 108 1-1/4 32 1 25.4 2
31012500 1-1/4 31.75 1.2500 4-1/4 108 1-1/4 32 1 25.4 2

 

 
INDEX

Last Updated on 11/14/01
By Bob Novak Media Development
Copyright Ó1999 CJT KOOLCARB Inc.